Abstract
Orthodontic miniscrews are exposed to three mechanical loading phases during clinical use: torsional loading upon insertion, flexural loading during anchorage function, and torsional loading upon removal. The aim of this study was to simulate clinical loading conditions for different types of orthodontic miniscrews in vitro to quantify the effects of combined torsional and bending stress. Various ...
Abstract
Orthodontic miniscrews are exposed to three mechanical loading phases during clinical use: torsional loading upon insertion, flexural loading during anchorage function, and torsional loading upon removal. The aim of this study was to simulate clinical loading conditions for different types of orthodontic miniscrews in vitro to quantify the effects of combined torsional and bending stress. Various orthodontic miniscrew systems (Lomas, Dual-top, Aarhus anchorage, Tomas-pin and T.I.TA.N.-pin) comprising 10 samples each were subjected to the following loading sequences in vitro: a torsional load corresponding to manual insertion with limited torque; and flexural loading at two different insertion depths. For all screw systems with torsional pre-loading (simulating insertion), subsequent flexural loading (simulating anchorage) yielded permanent deformations of approximately 0.15-0.25 mm, depending on the insertion depth. Since EDX analysis revealed comparable elemental compositions for the different screw systems, the differences in mechanical properties are attributed to screw design. Torsional loading during screw insertion may cause premature mechanical weakening and needs to be minimized. Unless fully inserted, screws show pronounced plastic deformation and hence fracture risk under subsequent flexural loading.
Altmetric